Floating crane hydraulic oil filter cleaning process:
Because the floating crane equipment car tank is large and heavy, and there are many oil pipelines, it is difficult to disassemble the crane for cleaning, and the oil tanks on many cranes are not removable, which requires everyone to master some methods when cleaning.
1. Before starting to clean the floating crane, the remaining oil in the car tank must be discharged. First turn off the oil supply power switch and the refueling power switch, then put in the appropriate gear oil, clean it, and then clean it.
2. For the cleaning of the hydraulic oil filter of the floating crane, it is also necessary to ensure that the appropriate gear oil can be used, the reducer is hung, and the relative lifting operation is performed to circulate the gear oil in the hydraulic transmission system to flush the residue in the oil channel;
3. Be sure to remove the return oil pipe, let the gasoline pump run, and the waste oil is discharged from the oil pipe. The relative hydraulic cylinder is fully extended. After all the waste oil is discharged, the car tank is refilled with new gear oil, the filter device is installed, and then the lubricating oil is installed.
Key points for safety management of floating crane operations:
Before the operation of the lifting machinery and equipment, it is also necessary to pay attention to check this galvanized steel wire rope, clutch device, brake system, commercial ratchet wrench, transmission pulley group, etc. During operation, the galvanized steel wire rope must be kept in the barrel for at least three turns. When performing floating crane operations, some personnel are prohibited from jumping over the galvanized steel rope of the crane, and the galvanized steel wire rope is prohibited from pulling the handle.
Safety management of floating cranes during operation. Pay attention to not leaving the post without authorization and do not let others operate the equipment at will. Listen to the signals of the commander during operation. If the signal is unknown or is likely to cause a safety accident, the operation should be suspended and continued after the status is clear. If there is a sudden power outage while the crane equipment is running, be careful to open the main switch to cut off the power immediately and put down the transported items.